Skip to Content

Stamping Die Data Summary

Stamping Die Data Summary

Submitted by • September 3, 2020 www.dgmfmoldclamps.com

The waste is essentially the reverse image of the formed hole. That is the same part of the opposite position. By checking the waste, you can judge whether the gap between the upper and lower molds is correct. If the gap is too large, the waste will have rough, undulating fracture surfaces and a narrow bright band area. The larger the gap, the larger the angle between the fracture surface and the bright zone. If the gap is too small, the waste will show a small angle fracture surface and a wide bright zone area.

Voted by:
Voted by DGMFmoldclamps

<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>